Table of Contents
Advertisement
•
Let the device cool down completely.
WARNING! Fire danger through hot parts. Let the device cool down
completely.
•
Demount reflector and all connection cables.
•
Clean the device if necessary. See Cleaning.
•
Put the device and all demounted elements into the original styrofoam box
and store them according to the requirements in the technical
specifications. See Technical Specifications.
12. Solve problems
Problem
Possible reason
Device is switched on,
Battery is not
but has no function
charged or charged
insufficient/defect
Micro-fuse is defect
Problem
Possible reason
Flash device has
Battery Pack or flash
function, but flash
device is defect
trigger is not possible
Flash tube is burnt-
out
Remedy
Charge battery/change
battery
Change micro-fuse, see
Change micro-fuse
Remedy
Contact Foto Walser
service department
Change flash tube, if
necessary with the help
of an electrician
18
13. Maintenance
13.1. Continuous inspections
What you should do?
Check all cables and plugs for damages. In case of
damage: WARNING! Danger of electric shock and fire
through short-circuit. The device/charger should be
repaired by an electrician immediately.
13.2. Cleaning
WARNING
Posterior danger of bursting of flash tube. Make sure not to touch the flash
tube with bare hands accidentally.
WARNING
Danger of electric shock
Just use the specified cleaning supplies.
The contact with moisture or water should be avoided.
Disconnect from power supply during cleaning.
Before every
operation
X
19
Advertisement
Table of Contents
