Program Progress - Beko WTV7825XCW1 User Manual

C
INFORMATION
• If no program is started or if no button is
pressed within 10 minutes during the
program selection process, the lights on
the display will turn off. The lights on the
display will come on again when the
program selector knob is turned or any
button is pressed.

4.3.13 Program progress

The progress of a running program can be
followed via the program progress light. At
the start of each program step, the
corresponding indicator light will light up.
C
INFORMATION
• If the "Anti-Crease+" auxiliary function is
selected, the "End" and "Anti-Crease+"
LEDs will light up simultaneously during
this step.
• To end the program while the "Anti-
Crease+" step is in effect, simply press any
button or turn the program selector knob.
While the program is running, you can
change the auxiliary functions, spin and
temperature settings without interrupting
the program. The change can only be made
to a step that is executed after the program
step that is currently running. If the change
is not compatible, the relevant lights will
flash 3 times.
C
INFORMATION
• If the machine does not proceed to the
spin step, the rinse hold function may
have been activated or the
automatic load imbalance detection system
may have been activated due to an
unbalanced distribution of the laundry in
the machine.
4.3.14 Loading door lock
The loading door of the machine has a locking
system that prevents the door from opening if
the water level is not suitable for opening the
door.
The loading door light will flash when the
machine is put into pause mode.
21 / NL
The machine checks the water level inside. If the
level is suitable, the loading door light will turn off
and the loading door can be opened in 1-2 minutes.
If the level is not suitable, the loading door
light will remain on and the loading door
cannot be opened. If you need to open the
loading door while the loading door light is
on, cancel the current program. See
"Cancelling the program"
To open the loading door in the event of
a power failure:
C
INFORMATION
• In the event of a power failure, you can
manually open the loading door using the
emergency handle located under the pump
filter cover.
a
WARNING!
• Before opening the loading door, make sure
that there is no more water in the machine
to prevent water from overflowing.
†
Switch off the device and remove the
plug from the socket.
†
Open the pump filter cover.
Washing Machine / User Manual