Beko WTV7825XCW1 User Manual page 8

1
Tighten the hose nuts by hand. Never
use a wrench when tightening the nuts.
2
When the hose connection is complete,
check for leakage problems at the
connection points by opening the valves
all the way. If there are leaks, turn off the
tap, remove the nut. Tighten the nut
again carefully after checking the seal.
Keep the taps of the product closed when
not in use to prevent water leakage and
resulting damage.
4.1.5 The drain hose
connect to the drain
• Attach the end of the drain hose directly to
the water drain, sink or bathtub.
a
PAY ATTENTION!
• Your floor will flood if the hose comes
out of its housing while draining
water. There is also a risk of burns
due to high
washing temperatures! To avoid such
situations and to ensure that the machine
takes in and pumps water without any
problems, the drain hose must be properly
secured.
• Connect the drain hose at a height of at least
40 cm and at most 100 cm.
8 / NL
• In case the drain hose is raised after being
at ground level or close to the ground (less
than 40 cm above the ground), water
drainage may become more difficult and
the laundry may come out soaking wet.
Therefore, follow the heights listed in the
picture.
• To prevent the drain water from flowing
back into the machine and to ensure easy
drainage, do not immerse the end of the
hose in the drain water and do not insert
more than 15 cm into the drain. If it is too
long, shorten it.
• The end of the hose must not be bent, it
must not be stepped on and the hose must
not be pinched between the drain and the
machine.
• If the hose is too short, use it by adding an
original extension hose. The hose should
not be longer than 3.2 m. To avoid failure
due to water leaks, the connection
between the extension hose and the
product drain hose must be properly fitted
with a suitable clamp so that it does not
come loose and leak.
4.1.6 Adjust legs
a
PAY ATTENTION!
• In order for your machine to operate more
quietly and without vibrations, it must be
level and balanced on its feet. Balance the
machine by adjusting the legs. Otherwise,
the product may move and cause
compression and vibration problems.
• Do not use any tools to loosen the locknuts.
Otherwise they may be damaged.
1
Loosen the locknuts on the feet by hand.
2
Adjust the feet until the product is stable
and balanced.
3. Retighten all locknuts by hand.
Washing Machine / User Manual