Table of Contents
Advertisement
4.1 Installation
• Consult the nearest authorized service
for the installation of your product.
• Site preparation and electrical,
water supply and
- drainage installations at the installation site
are the responsibility of the customer.
• Make sure that the water inlet and drain
hoses as well as the power cord are not
bent, pinched or squeezed when placing
the product in place after installation or
cleaning work.
• Make sure that the installation and electrical
connections of the product are
performed by an authorized service. The
manufacturer cannot be held liable for
damage caused by work performed by
unauthorized persons.
• Visually check the product for defects before
installation. In that case, don't install it.
Damaged products can pose a risk to your
safety.
4.1.1 Suitable installation location
• Place the product on a hard and flat floor.
Do not place it on deep-pile carpet or
similar surfaces.
• When the washer and dryer are placed on
top of each other, the total weight is
- when loaded - 180 kg. Place the product
on a firm and level floor that has sufficient
capacity to support the load.
• Do not place the product on top of the power cord.
• Do not install the product in environments
where the temperature may fall below 0 ºC.
• It is recommended to leave a gap on
the sides of the machine to reduce
vibration and noise.
• Do not place the product on a raised floor
next to the ledge or on a platform.
• Do not place heat sources such as hot plates,
irons, ovens, etc. on the washing machine or
use them on the product.
4.1.2 Remove packaging reinforcement
7/ NL
Tilt the machine
back to remove the
packing reinforcement.
Remove the packaging
reinforcement by pulling
on the ribbon
Pull. Enter this
not only act.
4.1.3 Removing the Transport
Locks
1. Loosen all bolts with a suitable wrench
until they turn freely
2. Remove the transport safety bolts by
turning them slightly.
3. Insert the plastic covers in the user
manual bag into the holes on the back
panel.
a
PAY ATTENTION!
• Remove the transport security bolts
before using the washing machine!
Otherwise, the product will be damaged.
C
INFORMATION
• Store the transportation security bolts in a
safe place for reuse for future
transportation.
• Install the transportation safety bolts in
the reverse order of the disassembly
procedure.
• Never move the product without the
transport security bolts securely in place!
4.1.4 Connecting the water supply
C
INFORMATION
• 10-80 liters of water per minute should flow
from the tap to keep your machine running
smoothly. Fit a pressure reducing valve if the
water pressure is too high.
a
PAY ATTENTION!
• Models with single water supply should
not be connected to the hot water tap. In
this case, the laundry will be damaged or
the product will switch to protection
mode and not work.
Washing Machine / User Manual
Advertisement
Table of Contents
