Fortin GM-SL2 Installation Manual

GM-SL2 GM-SL2
Copyright © 2006, FORTIN AUTO RADIO INC
DATA INTERFACE MODULE SELF-LEARNING FOR SECURITY SYSTEM AND / OR REMOTE STARTER.
WIRING / CONNECTION GUIDE WIRING / CONNECTION GUIDE
LED
START HERE
1
Make the connections of the GM-SL2 to the
vehicle:
Connector 1 (Black):
1.A
Determine the type of installation:
INSTALLATION WITH
INSTALLATION WITHOUT
Connector 2 (White):
(I) Locate the wiring type for the vehicle on the
1.B
VEHICLE FIT GUIDE (P.2)
(II) Make the connections associated with the vehicle in the
WIRING SCHEMATIC CONFIGURATION (P.3)
2
3
4
INSTALLATION WITH DATA-LINK INSTALLATION WITH DATA-LINK
Plan 1
WHAT IS DATA-LINK? WHAT IS DATA-LINK?
Starter
2 way
Alarm
Data-Link
ALL RIGHTS RESERVED
Lock
Unlock Driver 1
2
Ignition
(-) While running
Door trigger
Data OBD2
Bypass PK
3 (Type 3 only)
12V Battery (+) 1
Ground (-)
Data-Link
Data-Link
Connect wire to vehicle
INSTALLATION AND PROGRAMMATION INSTRUCTIONS INSTALLATION AND PROGRAMMATION INSTRUCTIONS
DATA-LINK ( See plan 1, below )
DATA-LINK (See plan 2, below)
Press and hold the programming
button. Plug in the connector 1
in the GM-SL2 interface.
The LED will turn on, indicating
the beginning of programming.
Plug the connector 2 into the
GM-SL2 interface.
WARNING: Connector 2 can be easily
plugged in backwards.
Starter or alarm
Data Link Port
2
1
Bypass
Lt. Blue/Black
Lt. Blue
White
White/
Black
Pink Pink/Black
Green
Blue
Orange
Orange/Black
Purple Purple/White or Purple/Black
Yellow
Yellow/Black
WARNING: Connector 2 can be easily plugged in backwards.
Red
Black
Blue
White
Connect wire to Remote-Starter/Alarm
5
6
7
8
9
10
INSTALLATION WITHOUT DATA-LINK INSTALLATION WITHOUT DATA-LINK
Plan 2
Cut off one plug of the
Data-Link connector,
connect the red wire
to +12V and the black
wire to ground.
The Data-Link is a connection between the remote-Starter/Alarm and the
Bypass/Interface module.
between devices by using bidirectionnal communication.
number of connections thus reducing installation error, and eliminates the risk
of theft. It very easy to install and saves up 60% of the installation time.
INSTALLATION GUIDE
Made in Canada - V1.8.g - 02 / 10 / 2007
W e b s i t e : h t t p : / / w w w . i f a r . c a
See wiring schematic configuration
Unlock Driver 2
Parking light
N./C.
N./C.
Data BCM
(Type 3 only) Bypass P 3
OUTPUT
While holding the programming
button, turn the key to the ignition
position.
The LED will flash rapidly.
Release the programming button.
Start the vehicle with the key.
The LED will turn off.
Turn the key OFF.
The interface is programmed.
Starter or alarm
2
1
Red +12V
Black
This connection eliminates all other connections
It reduces the
Trunk
K
INPUT
P.1