Fortin GM-SL Installation Manual

GM-SL
Copyright © 2006, FORTIN AUTO RADIO INC
DATA INTERFACE MODULE SELF-LEARNING FOR SECURITY SYSTEM AND / OR REMOTE STARTER.
WIRING / CONNECTION GUIDE WIRING / CONNECTION GUIDE
Front of the module
Connect wire to vehicle
Connect wire to Remote-Starter/Alarm
INPUT
OUTPUT
START HERE
1
Make the connections of the GM-SL:
Connector 1 (White, 10 pin):
(I) Locate the wiring type for the vehicle on the
1.B
VEHICLE FIT GUIDE (P.2)
(II) Make the connections associated with the vehicle in the
WIRING SCHEMATIC CONFIGURATION (P.3)
Connector 2 (White, 6 pin):
1.A
Make the connections
2
3
4
TECHNICAL SUPPORT / INFORMATION TECHNICAL SUPPORT / INFORMATION
Neither the manufacturer or distributor of this module is responsible of
damages of any kind indirectly or directly caused by this module,
except for the replacement of this module in case of manufacturing
defects. This module must be install by qualified technician. This
instruction guide may change without notice. Visit www.ifar.ca to get
latest version.
ALL RIGHTS RESERVED
Brown Parking Light
Blue
Purple
Unlock, mem Driver 1
White
1
Light Blue
Gray/Black Dome Light Supervision
Black/White
Pink
Red 12V BATTERY
Black
INSTALLATION AND PROGRAMMATION INSTRUCTIONS INSTALLATION AND PROGRAMMATION INSTRUCTIONS
(If necessary) .
Press and hold the programming
button. Plug in the connector 1
in the GM-SL interface.
The LED will turn on, indicating
the beginning of programming.
While holding the programming
button, turn the key to the ignition
position.
Ground In
Data
2
1 4 8
3 5 6 7
Lock
11 12 13 15
9 10 14 16
Trunk
Ignition
Ground
Brown/White
N.C.
Brown
N.C.
2
White/Black Unlock, mem Driver 2
White
Pink/Black
Pink
PK3
Bypass PK3: Connection needed ONLY
ON with the key in ON position (ignition).
MODELS ONLY
5
6
7
8
9
10
Special programming available on technical support internet site at
www.ifar.ca select GM-SL and installation manuals (Special Programming).
Technical support:
TEL: 514-255-HELP (4357)
FAX: 514-255-1367
Web: www.ifar.ca
INSTALLATION GUIDE
Made in Canada - V4.9.g - June 7, 2007
W e b s i t e : h t t p : / / w w w . i f a r . c a
See wiring schematic configuration
Door Trigger
Ignition IN
Ignition OUT
Pink, Yellow
Cut
or White
Black
if the Security light stays
FOR OLD CADILLAC
The LED will flash rapidly.
Release the programming button.
Start the vehicle with the key.
The LED will turn off.
Turn the key OFF.
The interface is programmed.
Plug in the connector 2
GM-SL interface.
Back of the module
in the
(If necessary)
P.1