Advertisement
Back Cover Locking-4
Station Name
NO
Part Number
1
7B11-030616-00105111
2
7B11-0313A4-00105113
3
4
5
1. Wastes produced by this station shall be placed in the assigned position. Refer to Waste Classification and Disposal List .
Notice
2. Install screws by the serial number (install one by one) and abnormalities such as screws being neglected, tilted and slipped are not allowed.
Figure:
Recent
Modification
Record
Model 32L31F\32L41F
Panel K320WD1 series
Amount
Descriptions
Φ3×6 countersunk-head black-zinc-plated machine
2
screws
Φ3×13mm flat-head flat-tail black-zinc-plated tapping
2
screws
Please read and understand the
operating instructions carefully
Document No.
Section/Serial No. Unit Assembly 24
Effective from
Operations and Requirements
Fasten back cover to the panel with two Φ3×6 screws.
Fasten back cover with two Φ3×13mm screws.
When finished, step on the switch with your foot to send the product to
next station.
3
1
4
2
Prepared by
Reviewed by Approved by
Take only
one screw
Xu Sijun
at a time
ITBC0224
v5.0
Version
2012-11-1
2012-11-1
Date Updated
Diagram
Tool Parameters
Figure 1
Electric screwdriver
Figure 1
5±0.5kgfcm
24
Process Requirements:
1. Check for rusted screws, missing
slots or bad cross slot.
2. Check if the electric screwdriver
torque force is within the specified
requirements.
3.When installing screws, align the
electric screwdriver and the screw to
the screw hole vertically (do not tilt).
4. In the process of installing screws,
properly exert pressure to make a
close contact between electric
screwdriver and screw slot to avoid
slipped screw.
5. Put the defective screws in the
defective product box and do not
throw them at will.
Project Controlled Seal
Advertisement
