Advertisement
I/O Baffle Plate Locking
Station Name
NO
Part Number
1
7B11-030696-00101111
2
7111-32L31F-41120C03
3
4
5
1. Wastes produced by this station shall be placed in the assigned position. Refer to Waste Classification and Disposal List .
Notice
2. Install screws by the serial number (install one by one) and abnormalities such as screws being neglected, tilted and slipped are not allowed.
Figure:
Figure 1
Recent
Modification
Record
Model 32L31F\32L41F
Panel K320WD1 series
Amount
Descriptions
Φ3×6mm B-head nickel-plated machine screws
2
32L31F\32L41F side baffle plate of mainboard (T9
1
MST6M182VG)
Please read and understand the
operating instructions carefully
Section/Serial No. Unit Assembly 08
Operations and Requirements
Take out the LVDS wire from the gap of mainboard.
Fit side baffle plate to panel back properly.
Fasten side baffle plate and mainboard to the panel with two screws.
When finished, step on the switch with your foot to send the product to
next station.
1
Take out the LVDS
wire from this gap.
2
Prepared by
Take only
one screw
Xu Sijun
at a time
ITBC0208
Document No.
Version
2012-11-1
Effective from
Date Updated
Diagram
Figure 1
Figure 1
Figure 1
Process Requirements:
1. Check for rusted screws, missing
slots or bad cross slot.
2. Check if the electric screwdriver
torque force is within the specified
requirements.
3.When installing screws, align the
electric screwdriver and the screw to
the screw hole vertically (do not tilt).
4. In the process of installing screws,
properly exert pressure to make a
close contact between electric
screwdriver and screw slot to avoid
slipped screw.
5. Put the defective screws in the
defective product box and do not
throw them at will.
Project Controlled Seal
Reviewed by Approved by
v5.0
2012-11-1
Tool Parameters
Electric screwdriver
5±1kgfcm
8
Advertisement
