Factory Mode Press the following key sequence on a standard RC transmitter: “8202” directly followed by MENU Purpose To perform extended alignments. Primary menu Secondary menu Value,remark MDOE VGA/YPBPR(SD)/YPBPR(HD),Selection R-GAIN G-GAIN Front-end gain adjustment B-GAIN ADC ADJUST R-OFFSET G-OFFSET Clamp level adjustment B-OFFSET AUTO ADC...
Page 24
GE/GOP PATTERN BMAP PATTERN Restore user default Factory reset PVR_RECORD ALL PVR Record on/off Power on/off/Mem Mirror Enable Mirror Enable enable Ageing mode Ageing mode enable Auto Volume on/off PVR Encrypt on/off Erase HDCP Key Erase Ci plus Key Qmap adjsut PQ setting PEQsetting Test pattern...
Trouble Shooting Procedure 1. No power(Connect to power, but all the indicator lights don’t work) Check 220V power supply voltage and the contact of power socket Check AC(220V)voltage and the contact of power socket. Check the two feet of the capacitors of the Check the power switch with 220V input or not, if yes, the power of mainboard after rectifying with switch broken, if no, it may the plug of the power cord plug...
Page 26
2. Red light can't start (Red light, remote control no reflect, no picture display) Check 5V SB voltage for abnormity If the 5V SB voltage in normal, press the remote If the 5VSB voltage with load is no or lower, control to check whether the control voltage of the please check the 5VSB related circuit)...
Page 27
3. No light (Boot the image flash protection, but you can see very dark images on the screen) Boot the image flash protection, but you can see very dark images on the screen, check the voltage for light bar on is ok or not Check the lamp plugs without ignition, lights on Check the output of light bar is in normal or not the lgith bar in the power moments are all bright...
Page 28
5. TV without channel or less channel or interfered Check TV antenna plug for looseness and poor contact Check whether the antenna plug or Check the voltage of power supply(3.3V) its signal source with problem of tuner IC in normal or not Replace 3.3V Check silicon high frequency IC in...
Page 29
7. AV (video) without picture Check whether the input interface of AV is connected (the related wires and sockets are connected by color, yellow is the video signal, red and blue are the audio signals), the menu source selection and the signal of the signal source are normal The signal source is in normal or not, other source wire check whether the signal source is...
Page 30
MSD3463 software upgrades (After Service) Method 1: The following update is for .bin file. 1. Rename the file to “MERGE.bin” 2. Prepare a USB memory. 3. Copy the software to USB flash disk(root directory). 4. Press [menu ], Choose [Option Settings], then press Software update],Software update menu will pop up when press confirm key, then select “Yes”...
Page 31
6. When the TV software is updated, the TV will turn on again automatically. Remove your USB flash drive. Method 2: Operations and procedure of software upgrading: 1). Changed the file name to "MERGE.bin", then stored software in the FA T32 format blank U disk. 2).
Page 32
MSD3463-T4C1( PAGE Content Index&History Rev Block Diagram Power & LED Driver System Power MSD3463 Video&VGA&USB&Amplify &LVDSpage HDMI page Tuner page History Rev Author DATE Description 7/2/2015 Ver:A1.0 First Version Release ZHQING 本文档仅限中国深圳市康冠技术有限公司和被呈送方内部使用,未经书面许可请勿扩散到第三方。 This document for ShenZhen KTC Technology CO., Ltd and presented party internal use only, Do not spread to third party without the written permission.