Table of Contents
Advertisement
Replace the accessories in ques-
▶
tion before operating the appli-
ance.
→ "Accessories", Page 28
Included with
the appliance
4.3 Requirements for the in-
stallation location
ATTENTION!
The appliance underwent a function
test before leaving the factory and
may, therefore, contain residual wa-
ter. This residual water may leak out
if the appliance is tilted at an angle
greater than 40°.
Tilt the appliance carefully.
▶
If the appliance is installed in areas
exposed to frost or outdoors, frozen
residual water may damage the appli-
ance and frozen hoses may crack or
split.
Do not install or operate this appli-
▶
ance anywhere that is liable to ex-
perience frost and/or outdoors.
Description
Tumble dryer
Accompanying
documents
Water drain hose
with connection
adapter, fixing
material and el-
bow.
→ "Water drain
hose", Page 14
Water jug
→ "Filling the wa-
ter tank",
Page 35
Installation and connection en
If the appliance is operated immedi-
ately after transportation, the refriger-
ant contained in the appliance may
result in damage to the appliance.
Immediately after transporting the
▶
appliance, leave it to rest for two
hours before putting it into opera-
tion.
Installation loca-
tion
On the floor
In a washer-dryer
stack
Requirements
Place the appli-
ance on a clean,
level and firm
surface.
Align the appli-
ance
→ Page 16.
Only use the ori-
ginal connection
set from the
dryer manufac-
turer when set-
ting up this appli-
ance in a
washer-dryer
stack.
This appliance
must only be
stacked on a
washing machine
from the same
manufacturer.
The depth and
width of this ap-
pliance must cor-
respond with the
dimensions of
the washing ma-
chine.
Do not place the
washer-dryer
stack on a plat-
form.
13
Advertisement
Table of Contents
