Table of Contents
Advertisement
Included with
the appliance
4.3 Requirements for the in-
stallation location
ATTENTION!
If the appliance is tilted at an angle
greater than 40°, residual water may
leak out of the appliance and cause
material damage.
Tilt the appliance carefully.
▶
Transport the appliance in an up-
▶
right position.
If residual water in the appliance
freezes, this may cause damage to
the appliance.
Do not install or operate this appli-
▶
ance anywhere that is liable to ex-
perience frost or outdoors.
If the appliance is operated immedi-
ately after transportation, the refriger-
ant contained in the appliance may
result in damage to the appliance.
Immediately after transporting the
▶
appliance, leave it to rest for two
hours before putting it into opera-
tion.
Description
Water drain hose
with connection
adapter, fixing
material and el-
bow.
→ "Water drain
hose", Page 14
Water jug
→ "Filling the wa-
ter tank",
Page 33
Installation and connection en
Installation loca-
tion
On the floor
In a washer-dryer
stack
Requirements
Place the appli-
ance on a clean,
level and firm
surface.
Align the appli-
ance
→ Page 16.
Only use the ori-
ginal connection
set from the
dryer manufac-
turer when set-
ting up this appli-
ance in a
washer-dryer
stack.
¡ Connection kit
with pull-out
worktop
→ Page 27
¡ Connection kit
→ Page 27
This appliance
must only be
stacked on a
washing machine
from the same
manufacturer.
The depth and
width of this ap-
pliance must cor-
respond with the
dimensions of
the washing ma-
chine.
Do not place the
washer-dryer
stack on a plat-
form.
13
Advertisement
Table of Contents
