Manual Layout - Canon CN8x15 Operation Manual

Manual Layout

Pages with instructions are organized as follows.
Chapter title
Function title
Summary of function,
points to note
Operating procedure
Notes
List of available
functions or options
Quick reference for
operating procedure
Page number
4. Operation in Full Mode
4.1.15 Assigning Functions to the Seesaw
The zoom seesaw switch can be programmed to control either the {Zoom} or {Iris}.
First, switch to the user for whom the settings apply.
(For instructions, see "4.1.3 Switching Users" or "4.2.1 User Screen Settings: Switching Users.")
Initial Top Screen
[ ]
MENU 1
[ Basic ] [Adj]
[ I-Gain ] [Trk]OFF
[I-Tq]H
Fr1P
A
1
Press
The previous or default function is highlighted.
[ ]
MENU MENU 1
RET
Fr1P
A 2 R
[ Z.M. ]
Zoom
Norm
AM
Press
2
The display starts blinking.
Zoom
3 Press
Press left or right to switch the function to
{Zoom} or {Iris}.
Iris
4
Press
The display changes from blinking to
[ ] highlighted, indicating con rmation.
MENU MENU 1
RET
Fr1P
A 2 R
[ Z.M. ]
Iris
Norm
AM
Options (D) Zoom
Description Zoom operation Iris operation
(D): Default value
MENU Zoom
× 6
E7
Important
six times and once.
.
Note: Note on Iris Assignment
1. The seesaw switch will no
longer control zooming.
or .
2. To control the iris with the
rocker switch, you must set
the iris mode to manual.
3. Press the Telephoto side to
open the iris, or press the
Wide end side to close it.
4. Zoom speed control
adjustments also apply to iris
.
control, and you can specify
the maximum iris speed. (See
"4.2.5 Zoom Screen Settings:
Specifying Maximum Zoom
Speed Control.)
Iris
or
E94
Introduction