Table of Contents
Advertisement
Keep all packing materials until the unit has been inspected.
z
Inspect the product to ensure there is no shipping damage. If any damage is detected
z
contact the dealer or retailer you bought the product from to report the damage.
Fisher & Paykel is not responsible for shipping damage.
z
Supplied
Spacers (4)
Moisture protection tape (1)
4 x 25mm screws (4)
4 x 13mm screws (5)
Sliding bracket (1)
3.5 x 11mm screws (2)
Required (not supplied)
UL-listed wire nuts (3)
Thread seal tape (1)
COMPONENTS REQUIRED
Drain hose support (1)
Sound seal (1)
Door panel template (1)
Exit vent (1)
3.9 x 38mm screws (6)
3/4" (19mm) Elbow
90° (1)
PARTS
Components for new installation only (available in hardware stores)
Air gap for drain hose
Wate tee for house
(use only if required)
plumbing (use only
if requried)
Hot water line with
Electrical cable or
ferrule and compression
Power cord kit - 5' 4"
nut - min 3/8" (9.5mm)
(163cm) or 7' 9" (236cm)
copper tubing or flexible
long depending on
braided hose
your installation
WARNING!
Ensure the power cord and connections comply with the National Electrical Code, Section
422 and/or local codes and ordinances. Maximum power cord length is 6 feet. A power Cord
Kit is available for purchase from an authorized Fisher & Paykel appliances dealer.
Check the house wiring. If it is not 2-wire with ground, a ground must be provided by
the installer. If the house wiring is aluminum, use UL-Listed anti-oxidant compound and
aluminum-to-copper connectors.
3/4" (16mm) Strain relief
Screw-type hose clamps
for electrical connection
Hand shut-off valve
(recommended)
5
Advertisement
Table of Contents
