Table of Contents
Advertisement
PUSH INTO CAVITY
1
2
3
4
14
Using a flat bladed screwdriver, turn to
raise the leveling feet. Level the rear,
outside legs first followed by the front
legs. Do not adjust the rear middle
leg yet.
Remove both screw covers before
partially pushing the product into the
cavity, pulling the hoses through as you
push to avoid crushing or twisting them.
Take care not to bend the legs.
Push the product from the outside
edges to avoid door damage.
Check the product sits level within
the cavity.
To access the rear leg adjustment,
remove the four screws holding the toe
kick and mounting plate in place.
If required, the rear middle leg can be
adjusted from the front of the product
using a 6mm Allen key.
Select desired spacer width and cut
to size. Remove adhesive and fit two
spacers to each side of the product.
Push the product into the cavity from
the outside edges taking care not to
damage the electrical cable. Guide
the cable through the channel under
the product on the right hand side
if required.
ELECTRICAL CONNECTION
1
2
3
Unscrew and remove the junction box
cover to access the terminal block.
Do not remove the screw holding the
junction box bracket in place.
Install the strain relief into the junction
box bracket and secure the house
wiring or the power cord and tighten.
Thread the wires through the hole in
the junction box bracket and connect
the incoming ground to green, white to
white and black to black.
Refit the junction box cover ensuring
all wires are clear of the cover. Ensure
the power cord is routed under
the dishwasher.
Ensure product does not have live
power until this installation is complete.
Advertisement
Table of Contents
