Table of Contents
Advertisement
Mifare & ISO14443A&ISO7816
http://www.jinmuyu.com
5.8 Reset the configuration parameter
If the output data changed, then need to reset the configuration parameters. Please pull the DIP switch SW1
to OFF, and SW2 to ON. After the device power up and start, user can normally setup the device parameter.
When parameter download finishes, pull the DIP switch SW1 to ON, then click "Reset" and restart the
device, the device will turn into working mode.
Setting steps:
.
to restart the device.
6 Application sample
Copyright © 2003-2014 Jinmuyu Electronics Co., LTD. All rights reserved.
14/17
Advertisement
Table of Contents
