Table of Contents
Advertisement
Quick Links
HOT SURFACE IGNITION FIRE PITS
(All Sizes from 13SS90 HSI to 43FSS300 HSI)
WARNING: If the information in this manual is not followed exactly, a fire or explosion
f i r e - p a r t s . c o m
may result causing property damage, personal injury, or loss of life.
Do not store gasoline or other flammable vapors and liquids in vicinity of this or any
other appliance.
What to do if smell gas:
•Do not try to light appliance.
•Do not touch any electrical switch; do not use any phone in vicinity.
•Immediately call your gas supplier from your neighbor's phone. Follow gas
supplier's instructions.
•If you can not reach gas supplier, call the fire department.
WARNING: REMOTE CONTROL USE: TO PREVENT ACCIDENTAL START UP
FROM UNWANTED RF SIGNALS, IT IS THE RESPONSIBILITY OF THE END USER
TO TURN OFF POWER TO ELECTRICAL OUTLET FOR THE REMOTE CONTROL
RECEIVER WHEN FIREPIT IS NOT IN USE. THIS SHOULD BE DONE VIA WALL
SWITCH OR BREAKER.
We require that our products be installed and serviced by professionals
who are certified in the U.S. by NFI (National Fireplace Institute) or in
Canada by WETT (Wood Energy Technical Training). Installer must follow
all instructions carefully to ensure proper performance and safety. Hearth
Products Controls is not responsible for your actions.
Please carefully follow the steps below when: 1) Selecting the Location. 2) Construction of the
Enclosure. 3) Installation of the Complete Fire Pit. It is the responsibility of the installer to follow all
Local and State Codes concerning the installation and operation of the fire pit.
4/2/2009
www.hearthproductscontrols.com
Toll Free: (877) 585-9800
INSTALLATION PREPARATION
828
Fax: (877) 433-0704
1
Advertisement
Table of Contents
Related Manuals for HPC 43FSS300 HSI
Summary of Contents for HPC 43FSS300 HSI
- Page 1 Fax: (877) 433-0704 HOT SURFACE IGNITION FIRE PITS (All Sizes from 13SS90 HSI to 43FSS300 HSI) WARNING: If the information in this manual is not followed exactly, a fire or explosion f i r e - p a r t s . c o m may result causing property damage, personal injury, or loss of life.
- Page 2 The steps listed as WARRANTY REQUIREMENT must be strictly followed to qualify for product warranty. Warranty will be void if not followed. 1) SELECTING THE LOCATION: WARNING: COMPLETE FIRE PITS ARE DESIGNED FOR OUTDOOR USE. HEARTH PRODUCTS CONTROLS CO. MUST BE NOTIFIED OF ANY OTHER USE. THIS PRODUCT MUST BE USED ONLY IN A FULLY VENTED (DAMPER FULLY OPEN IF INDOORS) AREA AND GLASS DOORS FULLY OPEN (IF INDOORS).
- Page 3 • WARRANTY REQUIREMENT: The fire pit assembly should be recessed a minimum of 4” from the top of the enclosure to protect flame from being blown out. Some areas may require more- 8” is not uncommon. • WARRANTY REQUIREMENT: All firepits come with a 13” x 13” sheet of insulation between pan and valve box to protect internal components from heat damage.
- Page 4 Fig. 1 Here is some additional helpful information to keep in mind: Fire Pits Dimensions: Are approximately 12” from the bottom of the valve box to the lip of the burner pan. HPC can provide drawings if so desired. f i r e - p a r t s . c o m Installation Collars are available that can be mortared into enclosure and allow for fire pit to be easily removed for maintenance.
- Page 5 Lava Rock & Glass Application Please follow the instructions below to add the finishing touch to your fire pit. Remember the deeper your lava rock or glass the more risk of reducing if not smothering the flame. Particular attention needs to be on the sensor assembly area- if sensor is covered, this will cause the pit to shutdown due to smothering flame around sensor or shorting out sensor rod.
- Page 6 Operating Sequence The following flowchart describes the basic operating sequence of the Hot Surface Ignition firepits. f i r e - p a r t s . c o m Troubleshooting The flowchart below provides specific troubleshooting information for the Hot Surface Ignition firepits. 4/2/2009...
Need help?
Do you have a question about the 43FSS300 HSI and is the answer not in the manual?
Questions and answers