Marantz CR2020 User Manual page 9

v
0 button
This button is used to enter the number "0" as well as to cancel various
operations.
b
Control buttons
Play ( ), Stop ( ), Pause ( ), FF (
These buttons are used when operating the CD player, TAPE deck, MD
player, etc.
The functions of these buttons are dependent on the function button
selected.
When TUNER is selected:
Pause ( ) Display button
FF ( ) Tuning UP
REW ( ) Tuning DOWN
NEXT ( ) PRESET UP
PREVIOUS ( ) PRESET DOWN
n
VOLUME e/
buttons
These buttons vary the listening volume. Press the
it and the button to decrease it.
m
MUTE button
Press to mute the sound from the speakers. When this button is
pressed, the speakers are muted and "MUTE" appears on the display
of the main unit. Pressing the button again cancels the muting function,
which can also be cancelled by pressing one of the function buttons.
,
DOOR button
If components of the Marantz Slim Line Series are connected through
the AL-Bus, the DOOR button allows the doors on the system
components to be opened or closed.
NOTE:
If the AL-BUS is not connected, OPEN/CLOSE operates the dooron this
unit only.
.
TRAY button
Opening and closing the CD compartment.
⁄0
BASS button
Press this button to boost the low frequencies. Press the button again to
return to normal.
⁄1
CLOCK button
If this button is pressed while the POWER switch is ON, the display
changes to the clock display and then returns to the previous display in
5 seconds.
Invalid during CD playback.
⁄2
SLEEP button
Press to set the sleep timer.
⁄3
EDIT button
Selecting EDIT mode to enter the recording time when making a tape
recording.
⁄4
TIME button
Selecting the time information you want to see.
⁄5
CANCEL button
— Erasing track numbers you do not wish to include in a program
(TAKE-OUT programming).
— Erasing track numbers from a program.
⁄6
PROG/MEMO button
This button is used to store a preset station in the memory or to program
a CD track.
), REW ( ).
button to increase
⁄7
REPEAT/P-SCAN button
When CD is selected:
Repeat (used to repeat the same tracks).
When TUNER is selected:
Press to initiate the tuner preset scanning.
Preset scanning receives the stations preset in the memory in
sequence for 5 seconds per station. When the desired station is
received, press the DOWN button; preset scanning is cancelled and
the station can be received in normal reception.
Pressing the UP button during preset scanning allows to skip the
received station.
⁄8
RANDOM/MONO button
When CD is selected:
Playing in random order.
When TUNER is selected:
Stereo/Mono (used to switch the tuner reception mode between
stereo and mono).
When TAPE is selected:
Direction (used to select side A or B).
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the
manufacturer. Discard used batteries according to the
manufacturer's instructions.
1. Remote control operation range
The remote control should be operated at a distance of less than 5 m
from the infrared sensor of the unit. Be careful not to point the
transmitter of the remote control in any direction other than towards the
infrared sensor and ensure that there are no obstacles between the
transmitter and infrared sensor, for these may make remote control
operation impossible.
Approx. 5m
8
CAUTION
60°