Marantz CR2020 User Manual page 6

CONNECTIONS
Connection of D-BUS Remote Control Bus
This unit is equipped with the remote control bus function. By
connecting it to Marantz system components equipped with remote
control (D.BUS/RC-5) jacks, such as a MD Deck and tape deck, these
components can be remote controlled from this unit.
Connect the D.BUS OUT jack of this unit to the REMOTE CONT.BUS IN
jack of another component using an RCA-type pin lead.
NOTE:
¼ If the connected component with the remote control (D.BUS/RC-5)
jacks has an INT/EXT switch on the rear panel, set the switch to EXT.
CR2020 rear panel TAPE deck rear panel
D. BUS
D. BUS
IN
IN
OUT
OUT
* Set to INT
R
ANNTENA
FM ( 75 ) GND AM
AUDIO BUS
R
LINE
L
R
IN
SYSTEM
AUDIO BUS
R
ANALOG
SYSTEM
IN
L
R
MD deck rear panel
D. BUS
IN
REMOTE
EXT.
SYSTEM
OUT
SYSTEM (AL-BUS)
SPEAKER SYSTEM
AUX SYSTEM
R L
IN OUT
L
R
6 OHMS
REMOTE BUS
D. BUS
IN
REMOTE
SYSTEM
OUT
OUT
Set to SYSTEM
REMOTE BUS
LINE
D. BUS
OUT OUT
IN
REMOTE
SYSTEM EXT. INT.
OUT
Set to SYSTEM
¼ If this unit is to be connected to a MD Deck and tape deck of the
Marantz Slim Line Series, refer to "System Connection through AL-
Bus" shown in below figure.
System Connection through AL-Bus
¼ Use the following connections if this unit is to be used in combination
with the Marantz Slim Line Series components.
NOTE:
If these components are to be stacked, always observe the stacking
order shown in this illustration, that is, the receiver on top, the tape deck
in the middle and the MD deck at the bottom.
CD DIG. OUT
D. BUS
IN
OUT
EXT.
DIGITAL
IN OUT
5
115V 220V~230V
VOLTAGE SELECTOR
115V 220V~230V
(K version only) Mains power plug
Mains power plug
VOLTAGE SELECTOR
110V~
Mains power plug
CR2020
SD2020
MD2020
220V~