Marantz CR2020 User Manual

Marantz CR2020 User Manual

Stereo cassette deck
Hide thumbs Also See for CR2020:

Advertisement

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE
OF PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES,
INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA
BORNE CORRESPONDANTE DE LA PRISE ET POUSSER
JUSQU'AU FOND.
NOTE TO CATV SYSTEM INSTALLER:
This reminder is provided to call the CATV (Cable-TV) system installer's attention to Article 820 – 40 of the NEC, that
provides guidelines for proper grounding and, in particular, specified that the cable ground shall be connected to the
grounding system of the building, as close to the point of cable entry as practical.
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio commu-
nications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by tuning
the equipment off and on, the user is encouraged to try
CAUTION
RISK OF ELECTRIC SHOCK
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alert the user
to the presence of uninsulated "dangerous voltage"
within the product's enclosure that may be of suffi-
cient magnitude to constitute a risk of electric shock
to persons.
The exclamation point within an equilateral triangle
is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the
appliance.
DO NOT OPEN
to correct the interference by one or more of the follow-
ing measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV techni-
cian for help.
NOTE:
Changes or modifications may cause this unit to fail to
comply with Part 15 of the FCC Rules and may void the
user's authority to operate the equipment.

Advertisement

Table of Contents
loading

Summary of Contents for Marantz CR2020

  • Page 1 CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
  • Page 2: Safety Instructions

    Any mounting of the appliance should follow the manufacturer’s instructions, and should use a mounting accessory recommended by the manufacturer. 9. Ventilation – Slots and openings in the cabinet are provided for...
  • Page 3 15. Lightning – For added protection for this video product receiver during a lightning storm, or when it is left un-attended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the video product due to lightning and power-line surges.
  • Page 4 ! 7 ! 9 @ 0 ! 8 @ 2 @ 3 @ 4 Figure 2 115V 220V~230V VOLTAGE SELECTOR 115V 220V~230V ! 5 ! 6 CD/TUNER AMPLIFIER CR2020 DOWN TUN/PRESET F. SEL FM/AM DISPLAY CLOCK MEMO PHONES...
  • Page 5 ¼ System remote control The remote control supplied with this unit can also be used to operate the MD Deck and tape deck of the Marantz Slim Line Series. In this manual, the controls on the main unit are enclosed in a circle, e.g.
  • Page 6 SYSTEM LINE ¼ If this unit is to be connected to a MD Deck and tape deck of the Marantz Slim Line Series, refer to “System Connection through AL- Bus” shown in below figure. System Connection through AL-Bus ¼ Use the following connections if this unit is to be used in combination with the Marantz Slim Line Series components.
  • Page 7 SYSTEM input/output jacks SYSTEM input/output jacks connect the MD deck and tape deck etc. of MARANTZ slim line series. SPEAKER SYSTEM terminals Connect the left and right speaker leads, observing the polarity of the leads and terminals.
  • Page 8 TIMER button This button is used when setting a timer program or checking the timer program contents after setting the timer. It is also used to cancel a set value. BASS button Press this button to boost the low frequencies. Press the button again to return to normal.
  • Page 9 DOOR button If components of the Marantz Slim Line Series are connected through the AL-Bus, the DOOR button allows the doors on the system components to be opened or closed.
  • Page 10 The RC2020CR Remote control is capable of controlling Marantz system components equipped with the D-Bus or AL-Bus jacks, such as a MD Deck and tape deck as well as this unit.
  • Page 11: Tuner Operation

    TUNER OPERATION The number of controls and buttons on the main unit are enclosed in k, and those on the remote control are enclosed in Before proceeding to tuner operation, press the FM/AM function button x of the remote control to set the remote control in the tuner mode. To listen to the tuner Set the VOLUME control @5 to the minimum position.
  • Page 12: Present Time Setting

    ON time, the power is turned ON in TUNER mode. NOTE: Timer operation of MD and TAPE can be activated only when the corresponding equipment is a MARANTZ Slim Line component connected to the main unit through a system cord. Flashing...
  • Page 13: Operation

    Caution in Timer Play. A. Be sure to set the present time before setting the timer operation. B. If the times set for two timer programs overlap, the timer will operate as follows. 1) If the ON time of one program comes after the ON time of the other program: (Example) PRG-1...
  • Page 14 Press the PLAY/PAUSE button on the set or the PLAY button on the remote control unit to start playback. The display shows the number of the currently playing track and its elapsed playing time. ¼ If playback or other operations are not possible from the remote control unit, the remote control unit is set to a mode other than CD.
  • Page 15 When the CD player is in the stop mode The total number of tracks on the disc and their total playing time are displayed. ¼ The display does not change even if the DISPLAY button !7 on the set or the TIME button ⁄4 on the remote control unit is pressed. Programmed playback of CDs Programming tracks Use the following procedure to program up to 30 tracks to play in the...
  • Page 16 FULL EDIT When recording CD tracks onto a tape, the tracks are allocated to tape sides A and B, and they are played and recorded by also using the erase function while leaving a blank space of 4 seconds between every track.
  • Page 17: Troubleshooting

    In the event of difficulty, refer to your dealer or write directly to the nearest location to you that is listed on the Marantz Authorised Service Station list. If writing, please include the model and serial number of the equipment together with a full description of what you think is abnormal about the equipment’s behaviour.
  • Page 18 MODEL CR2020 TECHNICAL SPECIFICATIONS FM TUNER SECTION Frequency range ... 87.5 –108 MHz Sensitivity ... 19.2 dBf S/N (Mono/Stereo) ... 75/65 dB T.H.D..0.3/0.6% Selectivity at 98 MHz ( 400 kHz) ... 65 dB AM TUNER SECTION Frequency range U version ...
  • Page 20 FM EXTERNAL ANTENNA FM FEEDER ANTENNA SYSTEM ANNTENA SPEAKER SYSTEM Assemble the AM loop antenna as shown in the figure before use. AM LOOP ANTENNA SPEAKER SYSTEM CD DIG. OUT D. BUS 6 OHMS Figure 3 AM EXTERNAL ANTENNA 115V 220V~230V VOLTAGE SELECTOR 115V...
  • Page 21 Manufactured under license from Dolby Laboratories Licensing Corporation. “Dolby,” the double-D symbol and “Pro Logic” are trademarks of Dolby Laboratories Licensing Corporation. is a registered trademark. Printed in Japan 97/10 SG 281J851250...
  • Page 22 CLASS 1 LASER PRODUCT LUOKAN LASERLAITE KLASS 1 LASERAPPARAT Model CR2020 User Guide MUSIC CONSOLE...

Table of Contents