Items For Which User Settings Are Available - Pioneer DDJ-SX Service Manual

5

8.3 ITEMS FOR WHICH USER SETTINGS ARE AVAILABLE

This unit is provided with user settable items, as shown below.
Item for Which User's
Setting is Available
Settings for DJ software other
than Serato DJ
Channel fader start setting
Change of the Master
Attenuator setting
Setting for flashing in
Slip mode
Demo mode setting
Velocity curve setting for
SAMPLER VELOCITY mode
MIDI setting for SAMPLER
VELOCITY mode
Illumination mode setting for
the jog dial
Each of the above items can be set in Utility mode.
To enter Utility mode, while holding the SHIFT and PLAY/PAUSE f buttons on the left deck pressed, turn the unit ON.
During Utility mode, the PLAY/PAUSE LEDs on both decks are lit.
After Utility mode is entered, the current setting for each item is indicated with the corresponding LED.
(For details, refer to the operating instructions.)
5
6
Setting Value (The factory default
settings are indicated in bold.) / Indication method
Serato DJ:
Software other than Serato DJ:
Channel fader start with sync:
Channel fader start without sync:
Channel fader start function disabled:
0 dB (without attenuation):
–3 dB:
–6 dB:
Flashing in Slip mode enabled:
Flashing in Slip mode disabled:
Demo mode enabled:
Demo mode disabled:
Curve 1 (Linear):
Curve 2:
Curve 3:
Curve 4 (3 steps):
3 ms:
4 ms:
13 ms:
Pattern 1 without dimmer:
Pattern 2 without dimmer:
Reverse pattern 1 without dimmer:
Reverse pattern 2 without dimmer:
Pattern with dimmer:
6
7
/ [KEY LOCK] unlit
/ [KEY LOCK] lit
/Left Effect Parameter button lit
on the left deck
/Center Effect Parameter button
lit on the left deck
/Right Effect Parameter button
lit on the left deck
/[HOT CUE] mode button lit
/[ROLL] mode button lit
/[SLICER] mode button lit
/[SLIP] button lit
/[SLIP] button unlit
/[TAP] button lit
/[TAP] button unlit
/[LOOP 1/2X] button lit
/[LOOP 2X] button lit
/[LOOP IN] button lit
/[LOOP OUT]button lit
/Number of LEDs of the level indicator lit: 0
/Number of LEDs of the level indicator lit: 1
/Number of LEDs of the level indicator lit: 10
/Only the PAD1 LED lit
/Only the PAD2 LED lit
/Only the PAD3 LED lit
/Only the PAD4 LED lit
/Only the PAD5 LED lit
DDJ-SX
7
8
Content to be
Part Name
Stored
IC24 UTILITY setting
(DSP PCB Assy) Setting value
8
A
B
C
D
E
F
33