Marantz RC1200 User Manual page 31

3. Use a ballpoint pen or other sharp point to
press the MODE button z on the
receiving unit to call up the CLONE and
RX displays. CLONE appears at LCD A
and RX at LCD B.
Press the OK Cursor button ⁄0 on the receiving
4.
unit.
Press the OK Cursor button ⁄0 on the sending
5.
unit.
commenced.
6. During the copying operation, the bar
displays at LCD C on both units start
moving from left to right. After the entire
bar displays have lighted, the display at
LCD B on the receiving unit changes to
RX OK and the LCD display on the
sending unit changes to TX OK. Copying
is now completed.
• Do not touch either of the remote
c o n t r o l l e r s d u r i n g t h e c o p y i n g
operation.
copying to fail.
• When copying has failed at an interim
point, RX NG will appear on the LCD
display of the receiving unit. Check
steps 1 to 5, and repeat.
POWER
SOURCE
ON
ON / OFF
LEARNING REMOTE
CONTROL RC 1200
The copying operation is now
CH
OK OK
Doing so may cause
30
OFF
MACRO MODE
VOL