Programming Macros - Marantz RC1200 User Manual

To go ahead with the clearing operation,
release the buttons, and press the OK
Cursor button ⁄0 .
Once the data is cleared, the codes are
either returned to their original display or
left empty. LCD is similarly returned to its
factory preset or left empty. All the macro
programs are also cleared.
• To cancel the memory clearing
operation, do not press the OK Cursor
button ⁄0 and simply touch any other
button.
After the OK Cursor button ⁄0 is pressed,
clearing the entire memory will take
approximately 10 seconds.

PROGRAMMING MACROS

Macros make it possible to use a single
function button to perform more complex
series of operations that would normally
require pressing several buttons. A single
button can be programmed to perform up to
10 steps in sequence. A typical example of
such a series might be as follows:
• Turn the main amplifier power ON
the function to DVD
Mode to Pro Logic
input Set the DVD player to PLAY.
• No signals may be transmitted during
macro programming.
• The various steps that make up a macro are
set initially to be sent one after another in 1
second intervals, however these intervals
may be shortened to as little as 0.5 seconds
or lengthened to as much as 5 seconds
using the Setup mode.
• In the macro mode, the number of steps the
macro contains is displayed on LCD c.
Macros may be programmed for each of the
11 function buttons, from LD to AMP.
1. Use a ballpoint pen or other sharp point to
press the MACRO button x until the
MACRO and LEARN indicators are
displayed blinking on the LCD.
ON
LEARNING REMOTE
CONTROL RC
POWER
SOURCE
OFF
ON / OFF
1200
MACRO MODE
20
Set the Surround
Switch the TV to video
Switch