Related Manuals for Makita BV17-177
Summary of Contents for Makita BV17-177
- Page 1 INSTRUCTION MANUAL Lockbolt Installation Tool BV17-177 Lockbolt/Blind Rivet Installation Tool BV13-177 IMPORTANT: Read Before Using.
-
Page 2: Specifications
Blind rivet or lockbolt (with NOT applicable Applicable breaking off a mandrel) NOTICE: Do not use BV17-177 for a blind rivet or lockbolt (with breaking off a mandrel). Otherwise the broken off mandrel jams in the tool and malfunction result. • Due to our continuing program of research and development, the specifications herein are subject to change without notice. -
Page 3: General Power Tool Safety Warnings
under the influence of drugs, alcohol or med- SAFETY WARNINGS ication. A moment of inattention while operating power tools may result in serious personal injury. Use personal protective equipment. Always General power tool safety warnings wear eye protection. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or WARNING: hearing protection used for appropriate conditions... - Page 4 may affect the power tool’s operation. If dam- accessories. aged, have the power tool repaired before use. Do not modify or attempt to repair the appli- Many accidents are caused by poorly maintained ance or the battery pack except as indicated in power tools.
-
Page 5: Functional Description
Only use genuine Makita batteries. Use of non-genuine Makita batteries, or batteries that have been altered, may result in the battery bursting causing fires, personal injury and damage. It will also void the Makita warranty for the Makita tool and charger. Tips for maintaining maximum Fig.1 battery life ► 1 . -
Page 6: Overload Protection
shown in the figure, it is not locked completely. automatically stop during operation if the tool or battery is placed under one of the following conditions: CAUTION: Always install the battery cartridge Overload protection fully until the red indicator cannot be seen. If not, it may accidentally fall out of the tool, causing injury to When the battery is operated in a manner that causes you or someone around you. - Page 7 Electric brake This tool is equipped with an electric brake. If the tool consistently fails to quickly stop after the switch trigger is released, have the tool serviced at a Makita service center. Fig.4 ASSEMBLY ► 1 .
- Page 8 Fig.7 Fig.10 ► 1 . Lock nut 2. Anvil holder ► 1 . Puller 2. Nose adapter Remove the anvil holder with a wrench while Installing the pulling unit (nose holding the nose adapter with another wrench. assembly) Once install the puller all the way until it contacts the surface of the joint.
- Page 9 Fig.13 ► 1 . Mounting area The side grip can be swung, allowing easy handling of Fig.12 the tool in any position. Loosen the side grip by turning ► 1 . Steel ball 2. Grooves on the joint it counterclockwise, swing it to the desired position and then tighten it by turning clockwise.
-
Page 10: Operation
CAUTION: Keep your hand and face away from the front part of the tool. The rivet or broken For model BV17-177, BV13-177 off mandrel may accidentally ejected, and you may be injured. Insert the pin into the hole. Attach the collar to the pin. - Page 11 Ask your local Makita automatically. Service Center for support. NOTICE:...
-
Page 12: Maintenance
Discoloration, deformation or cracks may result. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. OPTIONAL ACCESSORIES CAUTION:... - Page 13 To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan...