Connector And Jumper Description; Installing The Rocketraid 600L/600Ls Host Adapter - HighPoint RocketRAID 600L User Manual

4.2 Connector and Jumper Description

Connector
A1
F1
J1
Beep 1
Port
Connector
Active/FAIL LED PIN connector:
A 1-Pin connection from the HBA to an LED on the chassis. For
detailed LED connection requirements and display information,
please refer to the FAQ:
https://filedn.com/lG3WBCwKGHT7yNuTsFCwXy0/HighPoint-
Download/Document/Support/HighPoint_LED_PIN_Connector
_Standard.pdf

4.3 Installing the RocketRAID 600L/600LS Host Adapter

Note: Make sure the system is powered-off before installing the
RocketRAID host adapter.
The RocketRAID 600L/600LS series HBA may include both standard
and low-profile brackets. It may be necessary to attach the
low-profile bracket in place of the standard bracket, depending upon
the chassis design.
1. Open the system chassis and locate an unused PCI-E 2.0/1.0 (x4,
x8, x16) slot (or 3.0, x16) slot.
2. Remove the PCI-E slot cover.
3. Gently insert the RocketRAID 600L/600LS HBA into the PCI-E slot,
and secure the bracket to the system chassis.
4. After installing the adapter, attach the hard disks or backplane
enclosure to the host adapter using the appropriate cables.
5. Close and secure the system chassis.
RocketRAID RocketRAID
640L 642L
Active LED PIN
Fail LED PIN
I2C Connector
SATA
RocketRAID
644L
Alarm Buzzer
SATA and
eSATA
7
RocketRAID
644LS
N/A
N/A
N/A
eSATA Mini-SAS