Intel R1000GL Series Quick Installation User's Manual page 10

General Installation Process
Install Hard Drives ... Continued
3.5" Hard Drive Carrier (For system with 3.5" hard drive bay only)
A
Remove the drive carrier by pressing the
the lever.
B
Slide the carrier out.
D
Install the hard disk drive using the same four screws as shown. Make
sure the connector end of the drive matches the backplane connector.
Install 2.5" Hard Drive as option:
d1
Break off the tab on the
HDD interface bracket.
d1
0
Drive 0 Primary
green button and opening
B
A
D
d2
Install the HDD interface bracket
from top. Secure the bracket with
three screws as shown.
d2
Hard Drive Numbering Diagram
1
C
Remove the four screws securing the HDD interface bracket and remove
the HDD interface bracket.
E
With the lever open, insert the hard disk drive assembly into the chassis.
F
Push in the lever to lock it into place.
CAUTION: If you don't install
all drives, empty drive bays
must be occupied by carriers
with plastic drive blank
provided to maintain proper
system cooling.
F
d3
Slide the 2.5" HDD into the
bracket to align the screw holes
with the right and left rail.
d3
2
6
C
E
d4
Secure the hard disk drive using
the four screws for 2.5" HDD.
d4
3
4 x 3.5'' hard drive bay as shown