Jumper Settings - Supermicro AOC-A100G-b2CG User Manual

Super AOC-A100G-b2CM/G Add-On Card User's Guide
2-5

Jumper Settings

Explanation of Jumpers
To modify the operation of the mother-
board, jumpers can be used to choose
between optional settings. Jumpers create
shorts between two pins to change the
function of the connector. Pin 1 is identified
with a square solder pad on the printed
circuit board. See the motherboard layout
pages for jumper locations.
Note: JPAUX1 is for production use
only.
JPAUX1 for
Standby Power
Disable = No
standby power to
AOC NIC
Enable = Standby
power to AOC NIC
JPAUX1 for
Standby
Power
Disable = No
standby power
to AOC NIC
Enable =
Standby power
to AOC NIC
IPMI Support
Yes
Yes
Function
Disable jumper
to disconnect the
standby power
Enable jumper to
connect standby
power to AOC NIC
Connector
Jumper
FailOver Support
Yes
Yes
Notes
Default
WoL is supported but limited to plat-
forms with sufficient airflow when it is
in standby mode (S5 state). Please
consult Supermicro before enabling it.
2-6
1 2
Pins
Cap
1 2
Setting
Pin 1-2 (Short)
WoL Support
No
Yes
3
3