Kerf Block (Optional Accessory); Replacing Fluorescent Tube - Makita LS1214 Instruction Manual

1
1. Screw
2. Kerf block
3. Guide fence
32

Kerf block (optional accessory)

004861
CAUTION:
2
• When using the kerf block, always cut at the same Miter
3
angle.
• When changing the Miter angle, use other kerf blocks.
• When performing bevel cuts, never use the kerf block.
Failure to do so splits the block, causing a serious injury to
operator.
When you use the kerf block at 90° cutting, you can splinter-
005598
free cut in workpiece on the side of the guide fence (height of
the workpiece is up to 35 mm). Install the kerf block onto the
guide fence by means of the two screws. (Adjust the guide
fence and the kerf block so that they contact their faces.
Then tighten the screws securely.)

Replacing fluorescent tube

For LS1214F only
3
1. Pull out
3. Lamp box
5. Fluorescent tube
CAUTION:
• Always be sure that the tool is switched off and
unplugged before replacing the fluorescent tube.
• Do not apply force, impact or scratch to a fluorescent
tube, which can cause a glass of the fluorescent tube to
be broken resulting in a injury to you or your bystanders.
• Leave the florescent tube for a while immediately after a
use of it and then replace it. If not. You may burn
yourself.
Remove screws, which secure Lamp Box for the light.
1
2
4
002028
1
5
2. Push
4. Screws