Horizontal Vise (Optional Accessory); Vertical Vise - Makita LS1030N Instruction Manual

1
2
3
4
5
1. Vise arm
2. Vise rod
3. Guide fence
4. Holder
5. Holder assembly
6. Vise knob
7. Screw
3
2
4
1. Vise knob
2. Projection
3. Vise shaft
4. Base

Vertical vise

001796
6
The vertical vise can be installed on the guide fence or the
holder assembly (optional accessory). Insert the vise rod into
the hole in the guide fence or the holder assembly and
tighten the screw to secure the vise rod.
Position the vise arm according to the thickness and shape
7
of the workpiece and secure the vise arm by tightening the
screw. If the screw to secure the vise arm contacts the guide
fence, install the screw on the opposite side of vise arm.
Make sure that no part of the tool contacts the vise when
lowering the handle all the way. If some part contacts the
vise, re-position the vise.
Press the workpiece flat against the guide fence and the turn
base. Position the workpiece at the desired cutting position
and secure it firmly by tightening the vise knob.
CAUTION:
• The workpiece must be secured firmly against the turn
base and guide fence with the vise during all operations.

Horizontal vise (optional accessory)

001807
1
The horizontal vise can be installed on either the left or right
side of the base. When performing 15° or greater miter cuts,
install the horizontal vise on the side opposite the direction in
which the turn base is to be turned. By turning the vise knob
counterclockwise, the screw is released and the vise shaft
can be moved rapidly in and out. By turning the vise knob
clockwise, the screw remains secured. To grip the workpiece,
turn the vise knob gently clockwise until the projection
reaches its topmost position, then fasten securely. If the vise
knob is forced in or pulled out while being turned clockwise,
the projection may stop at an angle. In this case, turn the
vise knob back counterclockwise until the screw is released,
before turning again gently clockwise.
The maximum width of the workpiece which can be secured
by the horizontal vise is 130 mm (5-1/8").
CAUTION:
• Grip the workpiece only when the projection is at the
topmost position. Failure to do so may result in
insufficient securing of the workpiece. This could cause
the workpiece to be thrown, cause damage to the blade
or cause the loss of control, which can result in
PERSONAL INJURY.
13