Set-Up; First Use - Nevadent NSZB 3.7 A1 Operating Instructions Manual

CAUTION – PROPERTY DAMAGE!
The electric toothbrush may only be recharged with the supplied
►
charger. The appliance could otherwise be irreparably damaged!
GB
Only operate the appliance with the original accessories supplied.
►
MT

Set-up

NOTE
► In damp rooms, especially in the vicinity of
water (bath), the charger 5 must be fi rmly
fi xed to the wall to protect it from falling into
water.
1) Place the base 5 on a clean and level
surface.
Ensure the charger 5 cannot fall into water,
such as into a bath or sink.
16

First use

NOTE
Before starting to use the appliance, check that
it is in fault-free condition. If it is not, it must not
be used.
1) Insert the plug into the mains power socket.
2) Before initial use, clean the new brush heads 1
with fresh water.
3) Open the lid 3 and place the replacement
brush heads into the brush holders 4.
Re-close the lid 3.
4) Place the handset on the charger 5 so that
it slides onto the pin on the base.
5) Allow the handset to charge up for around
14 - 16 hours before using it for the fi rst
time. The charge indicator 6 on the front of
the hand appliance lights up red during the
charging process.
6) Use the handset repeatedly without charging
the battery until the performance becomes
noticeably weaker or the toothbrush stops
working and the charge indicator 6 blinks
red. Then recharge the battery for 14 - 16
hours. When the appliance is fully charged,
the charge indicator 6 lights up green.
7) Charge and discharge the toothbrush com-
pletely 3 times. The battery will have then
reached its full capacity.
NSZB 3.7 A1