Table of Contents
Advertisement
When using the disposable bag, be careful not to
vacuum heavy or sharp objects. When removing the
disposable bag, use a P2-respirator, and securley tie
a knot in the disposable bag. Do not make contact
with any sharp objects and then carefully dispose of
in accordance with legal regulations.
WET VACUUMING
Ensure that you read, understand, and apply the
safety instructions.
Reminder: DO NOT vacuum hazardous substances.
7
Install the supplied foam filter over the filter basket.
Plug the power cord into the power outlet and turn the
motor on by flipping switch to
position when finish vacuumming,and unplug the power
cord.
Empty and dry the tank.
The foam filter must be removed after wet vacuuming,
and a cartridge filter must be installed before dry
vacuuming again.
IMPORTANT!
When vacuuming large quantities of liquids, do not immerse
the nozzle completely in the liquid; leave a gap at the tip of
the nozzle opening to allow air inflow.
The machine is fitted with a float valve that stops the
suction action when the container reaches its maximum
capacity. You will notice an increase in the pitch of motor
sound. When this happens, turn of the machine, disconnect
from power supply, and drain the liquid into a suitable
receptacle or drain. To continue vacuuming, refit the
container with the drain cap. After wet vacuuming, turn the
machine off and remove plug from power supply.
Empty the container, clean and dry the inside and outside
before storage.
CONNECT ELECTRICAL APPLIANCES
8
Connect electrical appliance with Power Take Off on the
Vacuum, switch on electrical appliance, and flipping the
switch to
position. The vacuum cleaner will switch off
within 3-8 seconds once the electrical appliance switches
off.
WARNING
WARNING
position, and off to
WARNING
.
OVERLOAD PROTECTION
9
Overloading will activate the over current switch and cut
power to the take off. Press to reset the over current switch
to restore power to the take off.
SELF-CLEANING FILTER SYSTEM
10
Connect to the hose which has to insert to the vacuum
cleaner to make this system work.
Insert the power plug. Move the on/off switch to the
position.
Turn the air flow speed control to the MAX position.
Insert the air regulator nozzle into the filter self-cleaning
button and press 3-4 times.
Repeat the process two more times.
Press the filter self-cleaning button only if the catridge
filter is inserted.
CLEANING AND CHANGING HEPA FILTER
11
To ensure maximum performance, clean the HEPA
filter after each discharge cycle or if performance
drops. Replace the HEPA filter every 25 discharge
cycles.
Cleaning HEPA filter
The HEPA filter supplied is washable. Having a washable
filter helps increase its lifespan. Clean the HEPA filter on a
regular basis.
NOTE: Filter maintenance is important. Make sure the
HEPA filter is cleaned and replaced on a regular basis.
Helpful hint: When washing the HEPA filter it will need to
completely dry before reusing in the vacuum. We
recommend to always have a spare filter (not supplied) on
hand to replace in case of urgent use needed.
Changing HEPA filter
Replace the HEPA filter when loss of vacuum continues to
occur after you have checked for any obstructions in the
hose or wand. Also, install a new collection bag.
4
WARNING
WARNING
Advertisement
Table of Contents
