EVGA Z790 CLASSIFIED User Manual page 62

EVGA Z790 CLASSIFIED (121-RL-E798)
Configuring the Array
1. Attach all SATA devices you intend to use, and make sure power is attached.
Power the system on. Press the "Delete" key repeatedly to enter BIOS. Once
into BIOS you will need to enable the RAID function of the board.
2. Once into the BIOS, click on (or navigate with your arrow keys) the
"Advanced" tab at the top, and then on "SATA Configuration." You will see all
attached SATA devices at this point.
Note: The SATA Configuration menu shows a list of all drives currently detected by the
controller. Make sure the list in your BIOS matches what you have plugged in. If
it does not, reseat cables on the device(s) in question. If the issue persists,
please check the troubleshooting section on Page 104.
- 62 -