Advertisement
13. Loosen the cable support nut.
14. Pull the cable jacket down (toward the machine) until
there is no slack in the cable.
15. Tighten the nut on the cable support.
16. Zip tie the cable to the brace to the left of the fuel tank
and down the handle as shown in Figure 1.
Note: Make sure the self-propel cable does not kink
at the transmission.
Note: Make sure the BBC (Blade Brake Clutch) arm
does not interfere with the cable routing.
17. Reconnect the spark plug wire.
18. Using the Adjustments section in the Operator's
manual, check and adjust the self-propel drive and
BBC.
Figure 8
4
Advertisement
