Download Print this page

Servicing The Engine - Exmark TURF TRACER TT23KAEP Setup Instructions

Hide thumbs Also See for TURF TRACER TT23KAEP:

Advertisement

CAUTION
If the ignition is in the "ON" position there
is potential for sparks and engagement of
components. Sparks could cause an explosion
or moving parts could accidentally engage
causing personal injury
Be sure ignition switch is in the "OFF" position
before charging the battery.
3. Connect the negative battery cables.
Note: If the positive cable is also disconnected,
connect the positive (red) cable to the positive
battery terminal first, then the negative (black) cable
to the negative battery terminal. Slip insulator boot
over the positive terminal.
Note: If time does not permit charging the battery,
or if charging equipment is not available, connect
the negative battery cables and run the vehicle
continuously for 20 to 30 minutes to sufficiently
charge the battery.
Positioning the Discharge Chute
Loosen two 5/16 inch nyloc nuts attaching discharge
chute. Lower the discharge chute into position.
Retighten nyloc nuts until chute is snug but can pivot
freely.

Servicing the Engine

Refer to Engine Owner's Manual.
Servicing the Hydraulic Oil
The machine is shipped with hydraulic oil in the
reservoir.
1. Run the machine for approximately 15 minutes to
allow any extra air to purge out of the hydraulic
system.
2. Check hydraulic reservoir and if necessary fill the
reservoir to the appropriate level with Exmark
Premium Hydro oil.
3. Replace hydraulic reservoir cap and tighten until
snug. Do Not overtighten.
Note: The baffle is labeled "HOT" and "COLD".
The oil level varies with the temperature of the oil.
The "HOT" level shows the level of oil when it is at
225°F (107°C). The "COLD" level shows the level of
the oil when it is at 75°F (24°C). Fill to the appropriate
level depending upon the temperature of the oil. For
example: If the oil is about 150° F (65°C). Fill to halfway
between the "HOT" and "COLD" levels. If the oil is at
room temperature (about 75°F (24°C)), fill only to the
"COLD" level.
Filling Out the Product
Registration
Fill out the online warranty registration form and place
keys into literature pack.
5

Advertisement

loading