Advertisement
1. Deck support pin
2. The length of the rear deck support link assemblies
average 6.89 inches (approximately 6 7/8 inches)
(175.01 mm) from the center of the balljoint to the
center of the farthest hole. See Figure 3.
Note: All four pins must equally support the weight
of the deck. Adjustment in the length of the rear
deck support assemblies may be necessary. If one
side is longer than 6.89 inches (approximately 6 7/8
inches) (175.01 mm), than the opposite side must be
shorter by the same amount.
Left Hand Side Shown
Adjusting the Anti-Scalp Rollers
Adjust anti-scalp rollers for Normal Operating
Conditions. Place rollers in one of the positions shown
in Figure 4. Rollers will maintain 3/4 inches (19 mm)
Figure 2
2. Cutting height
Figure 3
clearance to the ground to minimize gouging and roller
wear or damage.
Note: For Maximum Deck Flotation, place rollers
one hole position lower. Rollers should maintain 1/4
inch (6.4 mm) clearance to ground. Do Not adjust
rollers to support the deck. Be sure roller bolts and nuts
are installed with the spring disc washer between head
of the bolt and mounting bracket.
For cutting heights above 3.5 inches (38 mm) use the
bottom hole. The rollers will still be effective against
1. Anti-scalp roller mounting
bracket
Four types of anti-scalp roller assemblies are available.
See Figure 5 to determine which assembly has been
installed on the unit. Torque hardware as specified, or
loss of roller may result. See Figure 5 .
3
Figure 4
scalping.
2. Cutting height
Advertisement
