Makita 9031 Instruction Manual page 5

Installing the side grip
For your own safety, always use the side
grip. Install it by screwing it firmly on the
grip holder. The side grip can be pivoted
for easy operation. See the figure a t right.
Side grip
can
pivoted
-
Side grip
Grip holder
Installing or removing the abrasive belt
CAUTION
:
Always be sure that the tool is switched off and unplugged before installing or removing
the belt.
Loop the belt over the front pulley. Hold
the tool as shown a t right and press down
to retract the front pulley so that you can
slip the other end of the belt over the rear
pulley. When pressing down the tool, be
careful not to allow the front pulley to
turn unexpectedly, causing you to lose
control of the tool.
NOTE :
The arrow on the inside of the belt and
that marked on the rear pulley must point
in the same direction.
Arrow
- ,
5