Table of Contents
Advertisement
Cable Connectors
Cables must have a male XLR connector on one end and a female XLR connec-
tor on the other end. This fixture offers both 3-pin and 5-pin connections.
INPUT
DMX -
2
1
Common
3
DMX +
Take It To The Next Level: Setting Up DMX Control
Step 1: Connect the male connector of the DMX cable to the female connector
(output) on the controller.
Step 2: Connect the female connector of
the DMX cable to the first fixture's male
connector (input).
Note: It doesn't matter which fixture address is the first one
connected. We recommend connecting the fixtures in terms
of their proximity to the controller, rather than connecting
the lowest fixture number first, and so on.
Step 3: Connect other fixtures in the chain
from output to input. You should place a DMX
terminator on the output of the final fixture to
ensure best communication.
Lens Barrels & Focusing
1.) Align and insert a lens tube (sold separately) into the shutter barrel.
2.) Install the top focus knob.
3.) Install the bottom focus knob.
4.) When in use, slide the lens barrel in/out to achieve proper focus, and
tighten the focus knobs to secure the lens.
Verismo™ Profile RGBALC - Rev. A
A Word on Termination:
OUTPUT
DMX is a resilient communication protocol, however
errors still occasionally occur. Termination reduces signal
errors, and therefore best practices include use of a
3
terminator in all circumstances. If you are experiencing
problems with erratic fixture behavior, especially over
long signal cable runs, a terminator may help improve
performance.
Page 8
DMX IN
DMX OUT
Next
Fixture
in Chain
DMX IN
© 2022 Blizzard Lighting, LLC
First
Fixture
in Chain
DMX OUT
Advertisement
Table of Contents
