Advertisement
Available languages
Available languages
WARNING: Covering or removing the fabric may take a few min-
utes and must be carried out by an adult.
MAKING THE BED
The crib can be unfastened from the parents' bed when making the
bed. Simply unfasten the buckles under the fabric lining.
When fastening the crib again to the parents' bed, pull the straps
again to make sure that the crib is correctly and securely fastened
to the parents' bed. Make sure that all the steps illustrated above
in "Side sleeping configuration (fastened to the bed)" have been
completed.
REMOVING THE COVER
23. Remove the mattress and open the snap buttons "E4" located
under the fabric structure.
24. Open the perimeter zipper "E1", the vertical zippers "E2" and
the horizontal zipper "E3". Remove the tube "C2" as indicated
in point 13. Pull the fabric off from the front until it has been
removed completely (Fig. 30).
DISASSEMBLING THE CRIB
The crib can be disassembled completely to put it away in the sup-
plied bag "G".
25. To disassemble the crib complete the steps described in the par-
agraph about "Removing the Cover".
26. Next, release the upper tube "C" by pressing on the pins "A7" and
pulling up on the tube (Fig. 31).
27. Release the central support structure "B" from the legs "A" by
acting on the pins "B2" and pulling up on the support structure
(Fig. 32).
WARRANTY
The product is guaranteed against any lack of conformity under nor-
mal use as specified in the instructions. The warranty shall not there-
fore apply in the case of damage caused by improper use, wear or
accidental events. For the duration of the warranty on conformity
defects please refer to the specific provisions of applicable national
laws in the country of purchase, where appropriate.
16
Advertisement
