Surge Protection; Starting The Engine - Champion 201110 Operator's Manual

201110 - 9200W ELECTRIC START GENERATOR

Do not expose to rain or use in damp locations.
Keep all objects a minimum of 5 feet (1.5m) away from the
generator at all times. Heat from the muffler surface and
exhaust gas stream can ignite combustible materials.

If you must operate in rain or damp locations, DO NOT operate
without proper protection of the electrical components.
Use of a safety canopy that is fire retardant and will provide proper
air ventilation for the engine exhaust gas stream may be used.
Visit championpowerequipment.com or call to find your Storm
Shield cover.

Surge Protection

Electronic devices, including computers and many programmable
appliances use components that are designed to operate within a
narrow voltage range and may be affected by momentary voltage
fluctuations. While there is no way to prevent voltage fluctuations,
you can take steps to protect sensitive electronic equipment.
– Install UL1449, CSA-listed, plug-in surge suppressors on the
outlets feeding your sensitive equipment.
Surge suppressors come in single- or multi-outlet styles.
They're designed to protect against virtually all short-duration
voltage fluctuations.

Starting the Engine

1. Make certain the generator is on a flat, level surface.
2. Disconnect all electrical loads from the generator. Never start
or stop the generator with electrical devices plugged in or
turned on.
3. Turn the gasoline fuel valve to the "ON" position.
WARNING
WARNING
Electric Start
1. Move the choke lever to the "CHOKE" position.
1a. For restarting a warm engine, move the choke lever to
75% of the "CHOKE" position.
2. Press and hold the ignition switch to the "START" position.
Release as the engine begins to start. If the engine fails to
start within five seconds, release the switch and wait at least
ten seconds before attempting to start the engine again.
If the ignition switch is held down in the "START" position
longer than 5 seconds it could damage the starter.
3. Do not over-choke. As soon as engine starts, move the choke
lever to the "RUN" position over a 2-5 second duration.
21
OPERATION
CAUTION
