Page 1
Quick Start Guide DM10 Version: 1.1 Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency betweenthe actual product and the written information in this manual.
Page 2
Appearance & Installation 1.Appearance Auxiliary input Wiegand reader Status of indicator Normal communication: The indicator EXTRS485 Wiegand reader flashes every two seconds. Abnormal communication: The indicator will glow constantly. The indicator flashes rapidly within 30s after the device is connected to the power supply.
Page 3
2)Fix the device with four screws RS485 AUX IN READER 1 READER 2 AUX OUT LOCK VOUT POWER RS485 ADD. Master DeviceConnection The DM10 has to be connected to F18(Master Device) to use the software. 485+ 485A 485- 485B DC12V DC12V DC12V RS485 AUX IN...
Quick Start After proper wiring, please follow the below instructions. 1. Set the RS485 address of DM10 as 2-9. 2. Set the F18 serial port as ”host” ([COMM.]> [serial port]). Step 1 Open the ZKAccess3.5 software, click [Device]> [New], enter the name and IP address of F18 , andthenclick [OK].
Page 5
After successful configuration, the Indicator LED flashes every two 2 seconds, indicating that the communication is normal. After adding successfully, the parameters of the access control unit could be set, please refer to the ZKAccess 3.5 user manual for further details.