Page 1
Button The Defender CA6150 Carbon Monoxide Alarm is Underwriters Laboratories Tested and Listed to the ANSI/UL 2034 residential safety standard. The CA6150 also provides added protection for your health, and enables you to monitor the current and peak CO levels as low as 10 PPM, and the duration of the peak level, at the touch of a button.
1. RECOMMENDED LOCATION OF ALARMS CO poisoning can happen anywhere in the building, but because most CO poisoning cases occur while people are sleeping, the best location for the CO alarm is in or near the sleeping area. If there is more than one sleeping area in the dwelling or on a different floor, or if bedroom doors are closed during Bedroom...
3. INSTALLATION INSTRUCTIONS Follow these steps in this order to install the CO alarm: 1. Fasten the mounting plate to the wall at eye level, about 5’ off the floor. Slide alarm down onto mounting plate. Connection between mounting plate and alarm will automatically turn activation switch ON.
Page 4
4. CONDENSED OPERATION INSTRUCTONS OPERATION: The CO alarm is operational once the activation switch is slid to position. If the alarm’s power is active, the green LED will POWER flash once every 60 seconds, and the LCD readout will continuously display ON, or the current CO level if 30 PPM or more is detected.
Page 5
LCD DISPLAY FUNCTION: When alarm is operating normally, the LCD will display ON or the current CO level if 30 PPM or more is detected. The LCD will display after ten years of operation to alert you that it is time to replace the alarm. Continuously Displays “On”...