Settings Of Jp1, Jp3, And Jp4 - NEC IE-703003-MC-EM1 Preliminary User's Manual

2.2 Settings of JP1, JP3, and JP4

Set the JP1, JP3, and JP4 in the pod as follows.
Notes 1. Differs from factory-set status.
2. Keep the removed connector attached to one pin as shown in the drawing below.
Remark IE-703002-MC operates under 5 V with the above described settings of JP3 and JP4, regardless of the
target system voltage.
10
CHAPTER 2 IE-703002-MC SETTING
Table 2-2. Settings of JP1, JP3, and JP4
Jumper
Note 1, 2
JP1 Open
JP3 Short
Note 1
JP4
1-2 short
JP1
Jumper contact
Status
1
2
3