Warnings - Agilent Technologies E444 AU Series Installation Manual

E444xAU IF Output Options

Warnings

WARNING The WARNING notice denotes a hazard. It calls attention to a
procedure which if not correctly performed or adhered to, could
result in personal injury. Do not proceed beyond a WARNING notice
until the indicated conditions are fully understood and met.
Warnings applicable to this instrument are:
WARNING
To prevent electrical shock, disconnect the Agilent Technologies instrument
from mains before cleaning. Use a dry cloth or one slightly dampened with
water to clean the external case parts. Do not attempt to clean internally.
WARNING
If this product is not used as specified, the protection provided by the
equipment could be impaired. This product must be used in a normal
condition (in which all means for protection are intact) only.
WARNING
For continued protection against fire hazard replace line fuse only with
same type and rating: Fuse 0.5A/250V, Part Number 2110-0202
The use of other fuses or material is prohibited.
WARNING
This is a Safety Class I product (provided with a protective earthing ground
incorporated in the power cord). The mains plug shall be inserted only into
a socket outlet provided with a protective earth contact. Any interruption
of the protective conductor, inside or outside the product is likely to make
the product dangerous. Intentional interruption is prohibited.
WARNING
These servicing instructions are for use by qualified personnel only. To
avoid electrical shock, do not perform any servicing unless you are
qualified to do so.
WARNING
The opening of covers or removal of parts is likely to expose dangerous
voltages. Disconnect the instrument from all voltage sources while it is
being opened.
WARNING
This product is designed for use in Installation Category II and Pollution
Degree 2 per IEC 61010-1: 2001.
WARNING No operator serviceable parts inside. Refer servicing to qualified personnel.
To prevent electrical shock do not remove covers.
WARNING If this product is not used as specified, the protection provided by
the equipment could be impaired. This product must be used in a
normal condition (in which all means for protection are intact) only.
Installation Guide
E444xAU Options H20, H25 and H70
Safety and Regulatory Information
29