NEC MultiSync X555UNV User Manual page 30

1
LONG CABLE COMP*
(Analog input only)
ON/OFF
SOG PEAK
GAIN
R-H.POSITION
G-H.POSITION
B-H.POSITION
SYNC TERMINATION
INPUT CHANGE
TERMINAL SETTING
DVI MODE
D-SUB MODE
BNC MODE* 1
1
SCART MODE*
DisplayPort
HDMI SIGNAL
DEINTERLACE
ON
OFF
*1: This function depends on which option board you use.
*2: Multi-Stream Transport requires the corresponding display card. Contact your dealer for limitations of this function.
Manually compensates for image degradation caused from using a long cable.
ON: Activates this function.
OFF: Deactivates this function.
Adjusts the sensitivity of the Sync On Green input signals. Adjusts the slice level when separating
synchronization from sync On Green signal input. Press "LEFT" or "RIGHT" to select.
Adjusts gain value.
Adjusts the position of the red component of the image.
Adjusts the position of the green component of the image.
Adjusts the position of the blue component of the image.
Selects the terminate resistance for matching the cable impedance.
Sets input change speed. When selected "SUPER", allows to switch high-speed between set two
signals.
NOTE: When "QUICK" is selected, picture may be distorted when signal input is changed.
"SUPER" is released when selecting IMAGE FLIP except for NONE.
This function should be chosen after all adjustment options have been made for the input.
Selects the kind of DVI-D equipment which is connected to the DVI input.
Select "DVI-HD" when DVD player or computer equipment, which requires HDCP authentication,
is connected.
Select "DVI-PC" when a computer equipment, which not requires HDCP authentication, is
connected.
Selects the type of signal associated with the D-SUB input.
RGB: Analog input (R, G, B, H, V)
COMPONENT: Component (Y, Cb/Pb, Cr/Pr)
Selects the kind of equipment which is connected to the BNC input.
RGB: Analog input.
COMPONENT: Component.
Input mode for devices using SCART connectors.
Selects DisplayPort mode [1.1a] or [1.2].
[1.2] should be selected when using Multi-Stream Transport.*
RAW: Disable the expanded feature.
EXPAND: Expand image contrast and increase detail in the dark and bright areas.
Selects the IP (Interlace to Progressive) conversion function.
NOTE: For DVI input "DVI-HD" needs to be enabled in the DVI mode menu. When INPUT2 of
SUPER is selected in INPUT CHANGE and displayed, this function cannot be changed.
Converts interlaced signals to progressive. This is the default setting.
Disables IP conversion. This setting is best suited for motion pictures, but increases the risk of
image retention.
2
English-28
OFF
0
0
0
0
0
HIGH
NORMAL
DVI-HD
RGB
RGB
OFF
1.1a
Depends on
signal input
ON