Base Setup; Installing The Side Brushes - Shark NINJA IQRobot UR1000SR Series Owner's Manual

3 ft.
3 ft.
5 ft.
SharkMat
(for use on carpet)
The Self-Empty Base charges your robot and holds dirt and debris from up to 15 days of cleaning. Select
a permanent location for the base, because every time you relocate it, your robot will have to completely
re-map your house.
Choose a level surface in a central area. Remove any objects that are closer than 3 feet from either side of
the base, or closer than 5 feet from the from the front. Place the base with its back against the wall in an
area with a good Wi-Fi signal. Set up the base on bare floor, or on the SharkMat. Plug in the Charging Cord,
and turn on the power switch on the back of the base. The base must be plugged in continuously for the
robot to find it. The Indicator Light will illuminate green when the base has power.
NOTE: For best results, set up on bare floor or thin carpet with the SharkMat.
NOTE: Do not place base against heating elements or baseboards, or in direct sunlight.
NOTE: Every time the robot returns to the base, it will make a loud noise as it empties its debris. This is normal and should
not be a cause of concern.

INSTALLING THE SIDE BRUSHES

s h a r kc l e a n . c o m

BASE SETUP

Snap the 2 included Side Brushes located in the
red packaging, onto the square pegs on the bottom
of the robot.
IMPORTANT: The Shark iQ Robot® has a pre-installed rechargeable battery. Battery should be fully charged
before using. It may take up to 6 hours to fully charge.
To charge, the Power button on the side of the robot
must be switched on (by pressing "I"). The robot will
beep when charging begins.
If the robot has no charge and cannot return to
the base, manually place it on the base. The base
indicator light will flash blue and the robot will
beep when charging begins.
NOTE: When manually placing the robot on the base, make sure the Charging Contacts on the bottom of the robot are
touching the ones on the base and the robot's dust bin is touching the debris intake on the base. While the robot is
charging, both blue LED lights will flash. When charging is complete, both blue lights will illuminate steadily.
NOTE: When picking up the robot be careful not to place fingers between the bumper and the base of the robot.
CHARGING
When the cleaning cycle is complete, or if the battery
is running low, the robot will search for the base.
If your robot doesn't return to the base, its charge
may have run out.
s h a r kc l e a n . c o m