Shark UV219CS Owner's Manual

Bagless upright vacuum limited edition

Advertisement

Quick Links

BAGLESS UPRIGHT VACUUM
OWNER'S MANUAL
Model UV219CS
120V., 60Hz., 12 Amps
FOR HOUSEHOLD OR COMMERCIAL USE
USA: EURO-PRO Operating LLC
94 Main Mill Street, Door 16
Plattsburgh, NY 12901
Tel.: 1 (800) 798-7398
www.sharkvac.com
Canada: EURO-PRO Operating LLC
4400 Bois Franc
St. Laurent, QC H4S 1A7

Advertisement

Table of Contents
loading

Summary of Contents for Shark UV219CS

  • Page 1 BAGLESS UPRIGHT VACUUM OWNER’S MANUAL Model UV219CS 120V., 60Hz., 12 Amps FOR HOUSEHOLD OR COMMERCIAL USE USA: EURO-PRO Operating LLC Canada: EURO-PRO Operating LLC 94 Main Mill Street, Door 16 Plattsburgh, NY 12901 Tel.: 1 (800) 798-7398 www.sharkvac.com 4400 Bois Franc...
  • Page 3: Important Safety Instructions

    Printed in China IMPORTANT SAFETY INSTRUCTIONS When using your SHARK Bagless Upright Vacuum, basic safety precautions should always be observed, including the following: Read all instructions before using this vacuum. WARNING: To reduce the risk of fire, electrical 13.
  • Page 4: Precautionary Measures

    PRECAUTIONARY MEASURES Important: If the suction opening in the unit, the hose or the extension tube become blocked, switch off the vacuum cleaner and remove the blocking substance before you start the unit again. Do not operate the vacuum cleaner to close too heaters, or radiators.
  • Page 5: Problem Solving

    PROBLEM SOLVING This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem occurs, it usually can be solved quite easily when the cause is found. Therefore, this checklist is provided for your convenience.
  • Page 6 On/Off button is in the "On" position. 14. Insert the right side of the agitator in Place vacuum in its upright position. Make sure that the vacuum cleaner is NOT plugged into the electrical outlet when adding or removing accessories.
  • Page 7 (Fig. 20) To select a pile height setting: 1. Turn vacuum cleaner "Off". 2. Select a pile height setting by Fig. 20 Suggested Pile Height Setting:...
  • Page 8 Do not use a hair dryer to dry it. Air dry only. To remove the pre- motor filter: 1. Remove the front cover from the vacuum cleaner. (Fig. 16) 2. Remove the dust cup (see there is a filter ring. instructions on page 5 for removing This is washable in the dust cup).

Table of Contents