Table of Contents
Advertisement
Data Cable Termination
1.
Strip off outer jackets of cables being daisy chained.
Shielded cables only: Cut foil or braid flush to outer jacket.
DO NOT cut drain (shield) wire.
2.
Strip insulation from each of the conductors.
3.
Bind the two cables around the end with electrical tape or
use a cable tie (see final drawing).
4.
Separate the blue and the blue-white wires from each other.
Then combine them with the matching wires from the other
cable; blue to blue and blue-white to blue-white.
5.
Twist remaining conductors ends with the matching colored
wires and fold ends in half. Isolate the unused pair with a
connector or tape.
6.
Reuse a wire insulation offcut (or heat shrink tubing) and fit
over drain wire.
7.
Terminate the wires on the pluggable screw terminal block.
(If used, shrink the heat-shrink tubing)
8.
Label or tag the cable appropriately.
16
th
February 2022
Dynalite Hardware
.......................................
Installation Guide
.......................................
Page 2
.......................................
www.lighting.philips.com/dynalite
Advertisement
Table of Contents
