Table of Contents
Advertisement
Controller Service Switch functions
The relevant Service Switch functions are:
•
3 pushes = All Channels 100%. You should do this to normalize the connected driver settings.
(DALI Broadcast Channels will setup the connected drivers with Min/Max/PowerOn/SystemFail levels,
and 2 second Fade Time).
•
4 pushes = A DALI enumerated controller will go into test mode and run a flash sequence for 5 minutes.
•
Push and hold for 5 seconds and release = Device reset
Controller Service LED functions
The Service LED has four signaling modes:
•
Blinking slowly (0.5Hz) = Normal operation.
•
Blinking normally (1Hz) = Network activity detected or DMX reception.
•
Blinking fast (4Hz) = Device communicating.
•
Permanently ON or OFF = Fault.
Some devices support a bicolor service LED. The same blinking pattern is valid for both Red and Green
D
LEDs. Red is the standard color for all devices. Green shows reception of DyNet heartbeat from another
DyNet device, such as a Gateway.
16
th
February 2022
Dynalite Hardware
.......................................
Installation Guide
.......................................
Page 17
.......................................
www.lighting.philips.com/dynalite
Advertisement
Table of Contents
