Table of Contents
Advertisement
CTD & CTDE
Vertical Contact Toasters
Open the conveyor doors.
5
For each door, lift slightly
from the bottom to unlatch
and guide down to the
surface.
Clean the release sheet. Put on neoprene gloves.
6
Dampen a clean cloth with lukewarm soap and water.
Wipe down both sides of the release sheet, making sure
all built-up sugar is removed. Wipe down both sides with
a clean cloth, dampened with water, to rinse. Allow to
air dry.
NOTE: Rotate sheets daily for longer life. Depending on
volume of product toasted, sheets should be replaced
every 4 to 6 weeks.
Reinstall the release sheet.
7
Clean the conveyors, inside of the doors, and bun
8
infeed. Wipe the conveyor with a clean cloth dampened
with Multipurpose Detergent Solution, rotating it as you
clean to reach its entire surface. Wipe the entire surface
with a clean cloth, dampened with sanitizer solution.
Dampen a clean cloth with lukewarm soap and water.
Wipe the inside of doors and bun infeed. Wipe the
inside of the doors and bun infeed again with a fresh,
clean, sanitized cloth.
Do not use abrasive cleaners or pads on the
conveyor surface.
Close the conveyor doors.
9
Reinstall the bun infeed.
10
Printed in USA 5/1/2022
Daily Planned Maintenance (continued)
CAUTION
Clean outside of the
11
toaster. Dampen a clean
cloth with lukewarm soap
and water. Wipe down the
outside of the entire toaster.
Wipe down the entire toaster
again with a fresh, clean,
sanitized cloth.
Maintaining Silicone Wraps
A. The Silicone wrap can be left on the unit for this
operation.
B. Open the door to gain access to the wrap.
C. Using a clean and damp rag, wipe the visible
surface of the wrap. After wiping, rotate the
conveyor forward and continue wiping, ensuring
the belt does a full 360 around the unit.
D. A clean and maintained belt should last
approximately 6 months, but varies by customer
and volume put through the toaster.
11
301-500revE-EN
Advertisement
Table of Contents
