Advertisement
1. Disconnect power supply.
2. Open the clamp by pulling the tab upwards.
3. Remove the fan casing from the base.
4. Attach the base to the mounting surface and mark the screw hole.
5. Drill holes; fix the fan base to the mounting surface with screws.
6. Install the body by tightly connecting the clamp
1
4
1. Remove the cover with a wide flat screwdriver. To do this, insert a screwdriver into the groove of the plug on the
terminal box casing and knock out the plug with a sharp blow.
2. Install the button in the drilled hole.
3. Connect, according to the diagram using RPI-M(n) 1.5-6.3 connectors (3 pcs., not included). To connect, it is
necessary to bring the wires into flat connectors and clamp them with a crimping tool. You can also connect the
contacts in other safe ways: by twisting, soldering, and welding.
ATTENTION! By installing the speed switch button, the protection level is reduced to Ip42.
Wiring connection diagram for models with flange
diameter 100-200 (for fans without speed switch
button)
CECYL fan installation instructions:
5
Installation instructions for the speed switch button:
CECYL wiring connection diagram
blue
N
(Neutral)
black
(High speed)
white
(Low speed)
Wiring connection diagram for models with flange
diameter 100-200 (for fans with speed switch button)
5
N
blue
(Neutral)
black
white
Advertisement
