Wendy's EVOLUTION ELITE EEG-15 Series Service Manual page 33

5-1. SPECIAL PROGRAM
MODE (Continued)
May 2012
Autolift Enabled (SP-21)
Press ► button and "SP-21 AUTOLIFT ENABLED?"
flashes in the left display. Press the ▲ or ▼ buttons
to choose "YES LIFT" or "NO LIFT". If fryer is fitted
with the auto-lift option, SP-21 must be set to"YES LIFT",
otherwise, set SP-21 to "NO LIFT".
Bulk Oil Supply (SP-22)
Press ► button and "SP-22 BULK OIL SUPPLY?"
flashes in the left display. Press the ▲ or ▼ buttons
to choose "YES SUPL" or "NO SUPL". Set to YES if the
oil is pumped into the vats from an outside oil reservoir.
Otherwise, set SP-22 to NO.
Bulk Oil Disposal (SP-23)
Press ► button and "SP-23 BULK OIL DISPOSE?"
flashes in the left display. Press the ▲ or ▼ buttons
to choose "YES DISP" or "NO DISP".Set to "YES DISP"
if the oil is pumped from the vats to an outside oil reservoir
when disarding the oil. Otherwise, set SP-23 to
"NO DISP".
Serial Number Log (SP-24)
Press ► button and "SP-24" and "S/N √EDIT" flash in
the displays, along with the serial number of the unit.
THIS SERIAL NUMBER SHOULD MATCH THE
SERIAL NUMBER ON THE DATA PLATE, ON THE
DOORS. IF NOT, IT CAN BE RECORDED.
Program Code Change (SP-25)
This allows the operator to change the program code
(factory set at 1, 2, 3) used to access Product Programming and
Level 2 Program Mode.
Press ► button and "SP-25" and "CHANGE MGR
CODE? 1=YES" flash in the display. Press
"ENTER NEW CODE, P=DONE, I=QUIT show scrolls
through the display. Press the product buttons for new code.
If satisfied with code, press
CODE, P=DONE, I=QUIT, shows in display. Press same
code buttons.
5-8
Model EEG-153, 154
and
and "REPEAT NEW